"Corey Woodworth" <cdw### [at] mpinetnet> wrote in message
news:3cb0bd95@news.povray.org...
> (ugh, I don't like making splines)

Is that because you can't figure out where your control points / nodes
should be?

Would a visual tool that created 2D splines for use in lathes, sors, prisms
be helpful? I am in the progress of playing around with such a tool, written
in VB, but am not sure if there would be much interest besides my own sense
of accomplishment.

Cheers!

Lieut_Data

Post a reply to this message